3 Series E36 328i (M52) TOUR
Cut new engine carrier to size to match cut on car and fit in with
straightening attachment (1).
Clean mating surfaces and drill holes for plug welding.
Produce reinforcement plates with width (B) of about 60 mm and
coat with zinc dust paint.
Insert reinforcement plates half their width into engine carrier and
plug weld.
Align partial replacement piece with straightening attachment (1)
and plug weld.
Weld engine carrier in welding joint.
Weld engine carrier to wheel housing.
Grind down and clean welded seam and welded spots.
Cut new transmission tunnel reinforcement plate to size to match
cut on car and fit in.
Clean mating surfaces and drill holes for plug welding.
RA Replacing left front engine carrier (without wheel housing) (partial replacement
BMW AG - TIS
09.02.2013 21:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
