3 Series E36 M3 (S50) CONVER
Turn engine twice in direction of engine rotation with special tool
11 5 100.
Ensure that groove on thrust bearing on intake camshaft is aligned
with groove on 1st bearing cover.
Note:
Due to technical revision, the dowel bore in the flywheel is
discontinued from 9/93. The Parts Service will now only
supply flywheels without dowel bores.
Check firing TDC position of cylinder 1 on mark between
vibration damper and underside of timing case cover.
On flywheels produced before 9/93, secure crankshaft in TDC
position with special tool 11 2 300.
Caution!
Do not turn the engine back.
Remove special tool before starting engine.
RA Replacing all camshafts (S50 B30)
BMW AG - TIS
09.02.2013 20:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 24 -