3 Series E36 M3 (S50) CONVER
Select a new tooth position by turning splined shaft.
Caution!
Before fitting VANOS adjustment unit again, always press
splined shaft back into initial position.
Repeat operation until helical gear engages in splined hub.
Repeat procedure on the intake end.
Note:
The splined shaft on the intake end is always approx. 5 mm
shorter.
If a new spline setting has to be sought on the intake end,
retract VANOS adjustment unit just far enough to leave
exhaust end in mesh.
On the exhaust end, align radial piston pump with driver on
splined hub.
Insert VANOS adjustment unit as far as timing case and secure to
timing case with two screws.
RA Replacing all camshafts (S50 B32)
BMW AG - TIS
09.02.2013 20:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 20 -