3 Series E36 M3 (S50) CONVER
Install chain guide of timing chain between intake and exhaust
camshafts.
Unfasten screw on VANOS adjustment unit and retract VANOS
adjustment unit from timing case until O-rings are exposed.
Clean and degrease sealing surfaces between end cover and
timing case.
Apply thin, uniform coat of Drei Bond 1209 sealing agent (refer
to BMW Parts Service).
Pay attention to dowel pins (1).
Caution!
The radial piston pump is no longer accessible after fitting the
end cover (VANOS bridge). Check position of radial piston
pump to driver on spline hub and realign if necessary.
Fit end cover (VANOS bridge) to timing case and tighten down.
RA Replacing all camshafts (S50 B32)
BMW AG - TIS
09.02.2013 20:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 24 -
