3 Series E36 M3 (S50) CONVER
Remove special tool 11 2 300.
Unfasten screws on VANOS adjustment unit and retract VANOS
adjustment unit from timing case until O-rings are exposed.
Clean and degrease sealing surfaces between end cover and
timing case.
Apply thin and uniform coat of 3 Bond 1209 sealing compound,
refer to BMW Parts Service.
Pay attention to dowel pins (1).
Caution!
The radial piston pump is no longer accessible after fitting the
end cover (VANOS bridge). Check position of radial piston
pump relative to driver on splined hub and realign if
necessary.
Fit end cover (VANOS bridge) to timing case and tighten down.
RA Adjusting timing of camshafts (S50 B32)
BMW AG - TIS
09.02.2013 20:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 13 -
