3 Series E36 M3 (S50) CONVER
Detach VANOS adjustment unit until hydraulic piston on exhaust
side is retracted.
Note:
Oil pump drive of toothed hub (1) can be positioned in such a
way that screw connection of toothed shaft is not accessible
as shown in illustration.
Crank engine in direction of rotation until oil pump drive of
toothed hub (1) is horizontal.
Caution!
CCW thread!
Brace against twin surface (1) and release hex head (2).
Pull off VANOS adjustment unit.
Note:
Splined shafts remain in VANOS unit on engine.
Installation
The installation of the VANOS adjustment unit is described
separately from the removal. The assembly sequence differs
between removal and installation.
Note:
Replace O-rings of VANOS adjustment unit and splined
shafts.
RA Removing and installing, sealing/replacing VANOS adjustment unit (S50 B32)
BMW AG - TIS
09.02.2013 20:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
