3 Series E36 M3 (S50) CONVER
23 21 007
Replacing transmission output flange
(S6S 420G)
Special tools required:
•
23 0 020
•
23 0 320
Note:
Remove output flange and radial seal.
The output flange is installed with a preload of 0.05 ...
0.22 mm.
Preload is set with the help of shims.
Calculating shims:
Screw on collar nut (1) without shim and tighten down with special
tool 23 0 020 / 23 0 320 .
Tightening torque 200 Nm.
Release collar nut (1).
Calculate distance "A" from flange surface to extension of output
shaft.
Example: "A" = 26.2 mm
RA Replacing transmission output flange (S6S 420G)
BMW AG - TIS
09.02.2013 22:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
