3 Series E36 M3 (S50) CONVER
Release screws.
Installation:
Replace self-locking nuts.
Install bolt with washer.
When tightening down, brace screw and turn nut. This
prevents the flexible coupling from being subjected to torsion
stress.
Tightening torque,
refer to Technical Data 26 11 1AZ.
Brace propeller shaft on centre mount and loosen nuts.
Installation:
Centre bearing must be aligned at right angles to propeller
shaft.
Tighten centre bearing in direction of travel (A = 2 ...4 mm)
Tightening torque,
refer to Technical Data 26 11 6AZ.
Caution!
Do not let propeller shaft fall into joints. In particular, on the
constant velocity joint, the rubber sleeve gets squashed or the
joint is damaged.
RA Removing and installing/replacing switch for gear recognition (SMG)
BMW AG - TIS
09.02.2013 22:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
