3 Series E36 M3 (S50) COUPE
Extract bucket tappets with Special Tool 11 3 250.
Installation:
Coat operating faces of bucket tappets with oil and install in
correct sequence, each allocated to correct cylinder.
Note:
Used bucket tappets must always be re-installed in same
tappet bore from which they were removed.
Place bucket tappets, arranged according to cylinder and in
correct sequence, on Special Tool 11 3 030.
Unfasten connection for engine ventilation.
Extract ventilation pipe by pulling downwards.
Installation:
Check O-ring at engine ventilation and replace if necessary.
RA Removing and installing or replacing timing case (upper section of cylinder head
BMW AG - TIS
09.02.2013 20:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
