3 Series E36 M3 (S50) COUPE
It should be possible to press piston pin into bush by hand using
only slight pressure. Clearance should then be minimal.
If necessary, replace connecting rods.
Note:
Inside any one engine, all connecting rods must share the
same weight class.
Spare connecting rods can only be obtained in complete sets.
Replace conrod bearing,
refer to 11 24 571.
Caution!
Piston and piston pin are paired and must not be fitted
individually.
Fit connecting rod with piston pin to piston in such a way that both
of the visible pair numbers on the installation direction arrow on
the piston point to the right.
Install retaining ring.
RA Removing and installing or replacing all pistons (S50) (engine removed)
BMW AG - TIS
09.02.2013 20:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
