3 Series E36 M3 (S50) COUPE
35 41 421
Replacing Bowden cable for throttle valve
actuation
Caution!
Adjust throttle cable after installation,
refer to 35 41 ...
Remove and install panelling for instrument panel,
refer to gr. 51
Disconnect Bowden cable on accelerator-lever shaft.
Installation:
Check rubber grommet (1), replace if necessary.
Compress retaining hook and pull Bowden cable out of engine-
compartment wall.
6-cylinder:
Compress nipple mounts on both lugs and press out of operating
lever.
Note:
Intake pipe was removed for demonstration purposes.
RA Replacing Bowden cable for throttle valve actuation
BMW AG - TIS
10.02.2013 02:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -