3 Series E36 M3 (S50) SAL
Caution!
Note direction and angle of rotation.
Rotate exhaust camshaft upwards from horizontal position on hex
head until groove in guide bearing is aligned with groove in 1st
bearing cover.
Caution!
Note direction and angle of rotation.
Rotate intake camshaft on hex head from horizontal position in
direction of rotation to approx. 10
°
position.
Brace timing chain on intake end and position sprocket with timing
chain on exhaust end:
-
For the spline hub right stop, the screws of the VANOS gear
must be positioned at least one half and at the most three-
quarters behind the blades of the impeller.
-
The left screw head side must be visible.
Brace timing chain and do not alter position of tooth hub on
exhaust end.
Insert intake sprocket in timing chain and place on centring sleeve
of intake camshaft:
-
Centre of one half of long hole is aligned with other edge of
timing case.
Note:
Position of long hole on intake sprocket is only important for
access to screws. It does not affect function.
RA Replacing all camshafts (S50 B32)
BMW AG - TIS
09.02.2013 20:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 14 -
