3 Series E36 M3 (S50) SAL
Disconnect pressure line from clutch slave cylinder and seal off.
Installation:
Tightening torque,
refer to Technical Data 21 52 1AZ .
Release nuts and remove clutch slave cylinder.
Installation:
Only install clutch slave cylinder provisionally to enable the
pressure line to be fitted in the correct position. The clutch
slave cylinder must be removed again to enable it to be bled.
Installation:
Clean pressure pin and support face on release lever.
Apply light coat of grease to pressure pin.
Grease, refer to BMW Service Operating Fluids.
RA Removing and installing/replacing clutch slave cylinder (SMG)
BMW AG - TIS
09.02.2013 23:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
