3 Series E36 M3 (S50) SAL
21 53 010
Removing and installing/replacing hydraulic
unit (SMG)
Note:
After finishing work:
Bleeding clutch hydraulics,
refer to 21 00 006.
Perform transmission adaption with BMW Diagnosis
System.
Caution!
Depressurize the hydraulic system. This involves:
Opening the cover on the E-box on the right spring strut shock
absorber and pulling off the relay (1).
Switch on ignition.
Actuate brake.
Shift selector lever from position "0" to "R" and/or "0" to "E"
until the transmission stops performing gear changes.
Note:
The gear indicator on the instrument cluster starts to flash
and/or the engaged driving range is no longer displayed. Also,
no shift noises can be heard from the transmission.
Switch off ignition.
Disconnect battery,
refer to instructions on disconnecting and connecting battery in
MG 12.
Open expansion tank (1) and reservoir (2) and draw hydraulic fluid
out of both containers.
RA Removing and installing/replacing hydraulic unit (SMG)
BMW AG - TIS
09.02.2013 23:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
