3 Series E36 M3 (S52) CONVER
Installation:
Clean sealing surfaces.
Drive alignment pins into timing case cover until they protrude
approx. 2 to 3 mm.
Installation:
Secure new seals to timing case cover with a little grease.
Installation:
Sealing faces clean and free of seal debris.
Apply Drei Bond 1209 sealing compound (refer to BMW Parts
Service) at following points:
•
A bead at the transitions to the cylinder head gasket on the
left and right.
•
Thinly and evenly to the entire sealing face of the timing case
cover to the cylinder head gasket.
Installation:
Install timing case cover, insert all screws and initially tighten to
approx. 5 Nm.
RA Removing and installing lower timing case cover (M52 / S52 / M52TU / M54)
BMW AG - TIS
10.02.2013 00:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -