3 Series E36 M3 (S52) CONVER
Caution!
Removal of propeller shaft: Mark universal joint to drive flange
of rear axle.
This will eliminate complaints of droning.
Remove universal joint from final drive.
Release nuts.
Tightening torque, 26 11 4AZ.
Installation:
Replace self-locking nuts.
Grip propeller shaft at center mount and release nuts.
Tightening torque 26 11 6AZ.
Installation:
Pretension center mounts in direction of travel 4 ... 6 mm (A).
Bend propeller shaft downwards at center mount and in so doing
detach centering mount on manual transmission/universal joint
from final drive.
RA Removing and installing propeller shaft - version with slide
BMW AG - TIS
10.02.2013 03:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -