3 Series E36 M3 (S52) CONVER
31 12 025
Replacing wheel guide joint in control arm
Special tools required:
•
11 7 360
•
31 1 430
•
31 1 441
•
31 1 443
•
31 1 445
•
31 1 446
•
31 1 447
•
31 1 448
Stabilizer connection on control arm:
Release nut (1).
Installation:
Replace self-locking nut (1). Use washer (2).
Tightening torque, 31 35 9AZ.
Unfasten nut (1) until in encounters spring strut. Position special
tool 31 1 430 with slanted surface (2) facing downwards and
remove wheel guide joint from stub axle with hammer blows (min.
2000 gr. hammer).
Installation:
Derust stub axle in area of contact face of rubber sleeve.
Bore and taper spigot free of grease. Replace self-locking nut.
Force wheel guide joint upwards using a transmission lifter
and base 11 7 360 ; this simplifies the tightening down of the
nut.
Tightening torque, 31 12 6AZ.
Mark out installation position of wheel guide joint on control arm
(colored mark).
Unscrew and remove nut.
RA Replacing wheel guide joint in control arm
BMW AG - TIS
10.02.2013 03:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -