3 Series E36 M3 (S52) SAL
Installation:
Remove sealing debris from sealing faces of cylinder head and
cylinder head cover.
Coat contact surfaces of joint with Drei Bond 1209 (refer
to BMW Parts Service).
Installation:
Apply a thin and even sealing bead of Drei Bond 1209 (refer
to BMW Parts Service) at transition to half-moon sections at
rear of cylinder head.
Check seals and replace if necessary.
Installation:
Make sure gasket is correctly seated on rear and front ends of
cylinder head.
Install cover bolts and align cylinder head cover.
Hand-tighten all cover bolts without preload. Tighten cap nuts
crosswise from inside to outside.
RA Removing and installing / sealing cylinder head cover (M52 / S52 / S50US)
BMW AG - TIS
10.02.2013 04:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
