3 Series E36 M coupe (S50) COUPE
Unscrew screws at front of cylinder head.
Remove holder for plug-in connections.
Installation note:
Tighten screws only after tightening cylinder-head bolts.
Unscrew cylinder-head bolts (moving inwards) in sequence 14 ...
1.
-
Remove cylinder head.
-
Remove cylinder-head seal.
Installation note:
Clean sealing face of cylinder head and crankcase; if
necessary, use hardwood scraper to remove sealant
compound. Make sure that no sealant compound falls into the
oil and coolant channels.
Installation note:
Coat projection between crankcase and timing-case cover
with 3 Bond 1209 sealing compound (refer to BMW Parts
Service).
RA Removing and installing cylinder head (S50)
BMW AG - TIS
09.02.2013 14:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
