3 Series E36 M coupe (S50) COUPE
Note:
Side sealing lips on glass roof cover and trim strips on roof
frame must not be crushed.
Installation of glass roof frame:
-
Take special tool 51 3 010 from tool trolley
-
Align at front (centering)
-
Lower towards rear
Adjust glass roof cover (refer to next work step).
Note:
The glass roof cover is adjusted immediately after installation
by pressing the glass roof frame down.
It is better to adjust the cover one millimeter lower because
only upward adjustment is possible once the glue has
hardened.
Ideal setting:
Distance (A) of glass roof cover to roof at front and rear must be
the same.
Insert credit or identity card between seal and glass roof cover.
The card must encounter the same resistance.
Height:
Front - flush to 1 mm deeper
Rear - flush to 1 mm higher
Caution!
Remove dirt from residual glue with Sika-Entferner 208
(Sourcing Reference: BMW Parts Service) before glue is
hard. In doing so, do not press out glass roof frame again.
Hardened glue can only be removed by machine.
RA Removing and installing complete glass tilt (frame) (Z3 Coupé, M Coupé)
BMW AG - TIS
09.02.2013 23:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -