3 Series E36 M coupe (S52) COUPE
Note:
If work has been carried out on the camshafts previously:
Rotate engine twice, then check camshaft adjustment.
Secure crankshaft with special tool 11 2 300 in TDC position of
1st cylinder.
Important!
Do not crank engine back.
Remove special tool 11 2 300 before switching on the
engine.
Fit special tool 11 3 240 to camshafts.
Note:
The timing is correctly set if the special tool 11 3 240 rests
without a gap on the cylinder head or protrudes up to 1 mm to the
inlet side.
The timing must be reset if the special tool 11 3 240 protrudes
to the exhaust side.
Remove special tool 11 3 240 .
Relieve tension on special tool 11 4 220 and remove.
RA Removing and installing or replacing VANOS adjustment unit (M52/S52)
BMW AG - TIS
09.02.2013 16:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
