3 Series E36 M coupe (S52) COUPE
Adhesive expiry date:
The repair set and glue cartridges are marked with an expiry date.
The glue cannot be used after this date.
Adhesive disposal:
Pure hardened adhesive is handled as normal waste.
The adhesive is disposed of in paper bags so that it can react with moisture.
Non-hardened adhesive, cartridges and mixtures of adhesive and solvents and the like must be disposed of as special
waste.
Removal of rear spoiler:
When cutting out the rear spoiler:
- Wear protective goggles and protective gloves.
The adhesive bead is cut through with a heavy-duty scalpel, if possible without damage to the rear spoiler.
To remove residual adhesive bead from rear spoiler and from rear window (if rear spoiler is to be reused):
- Use a scalpel for heavy-duty applications.
Treatment of glued area on rear spoiler:
Glue
Treatment
Original BMW
SikaTack - Ultrafast or Sikaflex 255 FC
a)
Clean with spirit (available in pharmacies).
b)
Air drying time at least 1 minute.
- In event of application to residual bead,
air drying time at least 15 minutes and immediate
gluing,
do not under any circumstances apply Sika
bonding agent 206.
c)
Only when residual adhesive bead has been
completely removed,
apply a thin coat of Sika bonding agent 206
d)
Air drying time at least 10 minutes
Preparation for assembly:
Prepare plastic nozzle for shaping adhesive bead; it can be cut during the air drying times.
.
Treatment of rear window (outside of window):
Glue
Treatment
Genuine BMW repair kit:
Part Number 81 22 9 407 497
Adhesive cartridge:
Part Number 81 22 9 407 526
a)
Clean with spirit (available in pharmacies).
b)
Air drying time at least 1 minute (at least 15
minutes when applying to the residual bead)
RA Rear spoiler gluing instructions
BMW AG - TIS
10.02.2013 00:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
