3 Series E36 M coupe (S54) COUPE
Remove VANOS adjustment unit towards front.
Feed out VANOS adjustment unit towards top (E85 only).
Note:
The toothed shafts (1) remain in the VANOS gear on the
engine.
Important!
The engine must not be cranked while the VANOS adjustment
unit is removed. The toothed shafts may move and slip out of
the toothing. The frictional connection of the camshafts will be
cancelled, and the valves could be exposed at the piston, or
the timing must be readjusted.
E85 only:
Installation:
For installation of VANOS adjustment unit in installed engine.
Attach special tool 11 7 130 and connect a compressed air
supply of 2 to 8 bar.
Briefly actuate buttons 1 and 3 on special tool 11 6 050 .
Both radial pistons (1) on VANOS adjustment unit must be
retracted (retarded setting).
Setting of radial pistons (1) on VANOS adjustment unit.
RA Removing and installing, sealing/replacing VANOS adjustment unit (S54)
BMW AG - TIS
09.02.2013 17:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
