3 Series E36 M coupe (S54) COUPE
Release screws.
Tightening torque 26 11 1AZ.
Installation:
Replace self-locking nuts.
Grip propeller shaft and release nuts.
Tightening torque 26 11 6AZ.
Bend propeller shaft downwards at center mount.
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
Note:
Pressure line remains connected.
Release nuts and remove clutch slave cylinder.
Tightening torque, 21 52 5AZ.
Caution!
Slowly relieve tension on clutch slave cylinder as otherwise air
will be taken in through sealing sleeve.
Detach locking clamp.
RA Removing and installing transmission (S5D 310Z)
BMW AG - TIS
09.02.2013 20:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -