3 Series E36 M coupe (S54) COUPE
Pull shift rod (1) out of shift rod joint (2) and remove washers (3).
Installation:
Grease shift rod pin (4).
Grease,
refer to BMW Service Operating Fluids.
Large contact surface of disks (3) must rest on shift rod joint
(2).
Detach cable from R gear switch.
Disconnect oxygen-sensor plug from bracket.
Attach special tool 11 8 022 to left and right control arms.
Caution!
Position special tool 11 8 022 in such a way that engine oil
sump rests safely on special tool.
Tight down knurled screws until special tool 11 8 022 rests
against engine oil sump.
Release screws and remove cross-member (1) with rubber mount.
Tightening torque, 23 71 1AZ/2AZ.
RA Removing and installing transmission (S5D 310Z)
BMW AG - TIS
09.02.2013 20:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
