3 Series E36 M coupe (S54) COUPE
54 10 100
Removing and installing glass tilt roof cover
(Z3 Coupé, M Coupé)
Press button and open glass roof cover.
Release locking washer (1) on left/right
and drive out pin (2) towards rear.
Installation:
If the pin cannot be installed at one end, close the glass roof
cover a little.
Push on new locking washer (1).
Caution!
During installation, make sure locking washers (1) are
correctly seated,
otherwise the glass roof cover will fly off.
Raise roof cover (1) at rear and remove towards rear.
Place roof cover on a clean surface.
RA Removing and installing glass tilt roof cover (Z3 Coupé, M Coupé)
BMW AG - TIS
10.02.2013 01:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
