3 Series E36 M roadst (S50) ROADST
Note:
Remember to fit suction pipe support to main bearing 5.
Note:
Always replace main bearing screws with new ones.
No oil is permitted in the blind bores (danger of cracking)
Screws washed and oiled.
Tightening specifications for main bearing:
1.
Tighten all screws on main bearing cover with jointing torque.
2.
Unfasten screws on main bearing cover 6.
3.
Strike back and front of crankshaft with plastic hammer to
centre thrust bearing (do not damage crankshaft).
4.
Tighten screws of main bearing cover 6 with jointing torque.
5.
Tighten all screws of main bearing cover with special
tool 11 2 110 or special tool 00 9 120 with torsion
angle.
Tightening torque,
refer to Technical Data 11 11 1AZ
Replacing conrod bearing shells,
refer to 11 24 571
Replacing grooved ball bearing in crankshaft,
refer to 11 21 571
RA Replacing crankshaft (S50)
BMW AG - TIS
09.02.2013 19:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
