3 Series E36 M roadst (S50) ROADST
Unscrew detent buffer on A-pillar until hood lid lies flush with
detent buffer and matches adjacent body parts.
Caution!
If detent buffer is unscrewed too far, there is a danger that the
hood lid will be damaged by contact surfaces of detent buffer!
Note:
Open door to improve access to detent buffers.
Turn detent buffer.
Caution!
Hood lid must not be twisted by detent buffer!
Check correct position of headlight in relation to hood lid.
Adjusting if necessary,
refer to 63 12 001
Gap dimension approx. 5 mm all round.
Caution!
Apply protective coat of anti-corrosion wax to both sides of
marked area of hood lid hinge to allow for any subsequent
paintwork which may be required, refer to BMW Parts Service.
RA Adjusting hood lid to fit (Z3)
BMW AG - TIS
10.02.2013 01:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -