3 Series E36 M roadst (S50) ROADST
Install clamping cables with brackets (to screw down, windshield
bracket should be vertical).
Attach convertible cover on left/right sides to B-pillar bracket.
Install screw in top left/right on the convertible top/B-pillar bracket.
Stow convertible top in its box.
Install side cover mount on windshield brackets at left/right sides.
Remove protective paper from double-sided adhesive tape, move
convertible cover over front of windshield bracket and secure
(position is specified by hole pattern).
Screw down frame rail on windshield bracket.
Screw down left/right frame rails on convertible top gasket.
Fit left/right frame rails for the convertible top gasket.
Caution!
The washers are refitted in the same location as noted during
disassembly.
Close and lock soft top.
Cement convertible tabs to the brackets.
Clip tensioning rail onto the brackets.
Fit convertible top gaskets to each side.
Fit edge protector on B-pillar/side panel.
RA Replacing convertible cover (Z3 roadster)
BMW AG - TIS
10.02.2013 02:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
