3 Series E36 M roadst (S52) ROADST
41 00 ...
Arrangement of shaped parts for cavity bulkhead
To reduce interior noise and to seal the interior from humidity, cavities in certain sections of the body are sealed off. To
do this, shaped parts are inserted in the cavities. The shaped parts expand to fit the contact faces perfectly by heating
the body to approx. 180
°
C and holding the temperature for approx. 20 minutes.
Since it is not possible during body repairs to heat the body up and maintain it at temperature for long enough, the
following procedure has been defined for this eventuality.
This procedure is described in
Installation of shaped parts for cavity bulkheads, with exception of cover for side member
.
Location of shaped parts for cavity sealing E36/7 Z3 Roadster
Location of shaped parts is marked by points.
-
(1) Carrier support in front wheel arch after the spring strut shock absorber dome,
Spare part already in expanded form
-
(2) Rear inside wheel arch beside connection point to rear wheel arch,
refer to 41 00 ... Installation of shaped parts for cavity bulkheads, with exception of cover for side member
RA Arrangement of shaped parts for cavity bulkhead
BMW AG - TIS
09.02.2013 23:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
