3 Series E36 M roadst (S52) ROADST
Make reinforcement plate from surplus sheet metal.
Width = 60 mm
Drill holes for plug welding.
Clean connection points.
Adjust reinforcement plate in engine support spare part to fit.
Clean connection points.
Install approx. 30 mm of reinforcement plate and weld into place.
Grind down welding point.
Drill holes for plug welding in vehicle engine support.
Clean connection points on engine support and coat with zinc dust
paint.
RA Replacing left engine support (partial replacement from front sub-frame) (Z3)
BMW AG - TIS
10.02.2013 00:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
