3 Series E36 M roadst (S52) ROADST
Weld engine support spare part to joint with reinforcement plates
all round.
Weld connection point on engine support/end wall from inside.
Grind welding spots until smooth.
Define connection point on spare part for carrier support (left end
wall) and mark points (a, b).
Dimension above (A) = 340 mm
Dimension below (B) = 280 mm
Note:
Measure between relevant edge of carrier support and joint.
Dimension (C) = 60 mm
Note:
Measure at center of bottom edge of carrier support.
RA Replacing left engine support (partial replacement from front sub-frame) (Z3)
BMW AG - TIS
10.02.2013 00:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
