3 Series E36 M roadst (S52) ROADST
Location of foam parts,
refer to 41 00 ... Location of shaped parts for cavity sealing.
If necessary, remove foam rubber from inner rear wheel arch.
Caution!
If vapors are emitted when the foam is removed, these must
be drawn off: ensure that the area is well ventilated!
Adjust spare rear inside wheel arch to fit using straightening angle
set and mark out holes for plug welding.
Mark out holes for plug welding in the convertible top
compartment.
Remove rear inside spare wheel arch and drill holes for plug
welding.
Clean and coat joint surfaces with zinc dust paint.
RA Replacing rear inside left wheel arch (Z3)
BMW AG - TIS
10.02.2013 00:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
