3 Series E36 M roadst (S54) ROADST
41 62 014
Adjusting trunk lid to fit (Z3)
Note:
Engine hood was fitted and screwed in an unfinished body
shell.
Unpainted surfaces become visible after subsequent
movement.
These surfaces must be touched up with paint in the body
color.
Unscrew detent buffers on left and right sides of trunk lid.
Loosen screws on lower section of trunk lid lock until it can just be
moved, enabling it to center itself.
The lower section of the trunk lid lock must not scrape against the
upper section.
Protect trunk lid to prevent it from dropping, then remove gas
pressure prop.
Caution!
Gas pressure props have high resistance.
RA Adjusting trunk lid to fit (Z3)
BMW AG - TIS
10.02.2013 04:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -