3 Series E36 Z3 coupe (M52) COUPE
Place Special Tool 26 1 030 on machined surface of final drive at
bottom.
Determine deflection angle,
refer to Technical Data.
Apply Special Tool 26 1 030 on rear section of propeller shaft and
measure angle.
Determine deflection angle of centre mount,
(refer to Technical Data)
and, if necessary, correct on transmission suspension or centre
mount by installing shims (up to max. 3 mm).
RA Balancing propeller shaft
BMW AG - TIS
11.02.2013 05:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -