3 Series E36 Z3 coupe (M52) COUPE
Punch mark both bearing caps.
Unscrew and remove both bearing caps.
Caution!
Don't mix up bearing caps and spacers.
Secure spacers on bearing cap with a piece of wire, if
necessary.
Installation:
Tightening torque, refer to Technical Data
Final drive housing bearings and backlash are adjusted with shims
(1).
Check O-ring (2), replacing if necessary.
Remove complete final drive housing.
Caution!
Don't bend the pulse spider.
Remove lockplate.
Unfasten nut (1) and brace with special tool 23 0 020.
RA Replacing input bevel gear and crown wheel (Type M) - final drive housing remove
BMW AG - TIS
11.02.2013 06:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -