3 Series E36 Z3 (M44) ROADST
18 12 030
Removing and installing / replacing rear
muffler (compact M41, M42, M43, M44)
Flange connection with compression spring
Loosen the flanged joint.
Separate exhaust.
Installation:
Replace self-locking nuts.
The screw heads must be located on the side of the
compression spring.
Alignment the flanged joint.
Note:
Sealing taper is produced by upset pipe.
Installation:
Lubricate flanged joint lightly with copper paste CRC, refer to
BMW Parts Service.
Turn flange until maximum possible ground clearance is
provided.
Align the flanges parallel to each another.
Align the exhaust system and insert the screws.
Caution!
Do not apply preload to compression springs on block.
Apply preload of measurement A to compression spring.
Tightening torque,
refer to Technical Data 18 00 4AZ
RA Removing and installing / replacing rear muffler (compact M41, M42, M43, M44)
BMW AG - TIS
11.02.2013 00:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -