3 Series E36 Z3 (M52) ROADST
Caution!
Different cylinder head bolts:
M10x95 for engines with cast iron engine block.
M10x110 for engines with aluminum engine block.
Cylinder head bolts must always only be used once.
There must be no oil in the tapped holes of the engine block
and the timing case cover.
Risk of cracking and distorted tightening values.
Install cylinder head and tighten down with new cylinder head bolts
(lightly oiled) in the sequence 1 ... 14.
Note:
For torsion angle adjustment, connect special
tool 11 2 250 to special tool 00 9 120.
Tightening Torque,
refer to Technical Data 11 12 6AZ
Tighten screw connection for timing case cover on cylinder head.
RA Removing and installing/sealing cylinder head (M52 / S52)
BMW AG - TIS
11.02.2013 00:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -