3 Series E36 Z3 (M52) ROADST
4.
Install 4 new toothed ring discs between front axle and
engine carrier, even if there were no toothed ring discs fitted
previously.
Tightening Torque,
refer to Technical Data 31 10 1AZ.
Installation:
Since 1993 models:
Four ring-type lock washers are omitted due to tapered connection
at both rear mounting points.
Screws M12 X1.5 X 95 9.8
Tightening Torque,
refer to Technical Data 31 10 1AZ.
Note:
Damaged threads in engine support should be repaired with
Helicoil thread inserts M12 x 1.5.
Unscrew left and right nuts.
Lower trolley jack slowly.
Caution!
Spring struts must not tilt outwards or sag - ball joints could be
damaged.
Installation:
Replace self-locking nuts.
Tightening Torque,
refer to Technical Data 31 31 1AZ
Caution!
M3: Long sheet-metal flange on thrust bearing must point in
forward direction.
RA Removing and installing complete front axle
BMW AG - TIS
11.02.2013 03:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -