bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

7 RA Raising Vehicle With Trolley Jack (vehicle Equipped With Jacking Point)|Page 297 > < 6 RA Notes On Using Repair Instructions, Technical Data, Tightening Torques
Page 1
background image

00 ... ...

Raising vehicle with trolley jack (vehicle
equipped with jacking point)

Warning!

Vehicles without jacking points (located in the middle of the
front axle carrier) must not be raised or moved with the trolley
jack!

 

Use only BMW-distributed/approved trolley jacks which have
rubber plate contact points.

Trolley jacks must be regularly serviced and always checked
for functional reliability before they are used!

To prevent the vehicle from slipping off the trolley jack, check
the rubber plate for damage prior to each use.

Raising vehicle at front:

Pay attention to the different versions of the jacking points.

Raise vehicle in area of marked surface (1).

If necessary, remove front spoiler/spoiler lip.

E67: Fit jacking point (purchase of part by way of Electronic Parts
Catalogue).

Slide trolley jack under vehicle at front middle until the rubber
contact plate is situated below the jacking point.

Raise vehicle with trolley jack.

RA  Raising vehicle with trolley jack (vehicle equipped with jacking point)

BMW AG - TIS

10.02.2013  23:50

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

7 RA Raising Vehicle With Trolley Jack (vehicle Equipped With Jacking Point)|Page 297 > < 6 RA Notes On Using Repair Instructions, Technical Data, Tightening Torques