3 Series E36 Z3 (M52TU) ROADST
Fit thrust washer (3).
Note installation direction of cup spring (2), "F" lettering must be
visible.
Note:
If "F" lettering is no longer visible on an engine that has been run:
Install cup spring (2) so that small locating diameter of spring (2)
points to sensor gear.
Fit cup spring (2) in position.
Position sensor gear (1) so that arrow on sensor gear faces
separating face of upper side of cylinder head.
Install nuts and tighten by hand but do not tighten down fully yet.
Withdraw toothed shaft (5) up to stop.
RA Replacing camshaft (M52TU / M54 / M56)
BMW AG - TIS
11.02.2013 00:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 16 -
