3 Series E36 Z3 (M52TU) ROADST
12 41 020
Removing and installing or replacing starter
(M52TU)
Follow instructions for disconnecting and connecting
battery,
refer to general information in MG12.
Disconnect and cover battery negative lead.
Remove intake filter housing,
refer to 13 71 000.
Disconnect plug connection (1) on air mass flow sensor.
Detach vacuum line (2) from intake hose.
Release hose clip (3).
Pull throttle cable upwards out of retainer (1) and unhook from
throttle actuator.
Installation:
Adjust throttle cable for throttle actuator,
refer to 35 41.
Release hose clamps (1).
Detach intake hose piece from throttle assembly and idle-speed
control valve.
RA Removing and installing or replacing starter (M52TU)
BMW AG - TIS
11.02.2013 01:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -