3 Series E36 Z3 (M52TU) ROADST
13 41 500
Replacing idle speed control valve (M52TU,
M54)
Necessary preliminary tasks:
•
Switch off ignition.
•
Disconnect battery ground wire.
•
Observe instructions for disconnecting and connecting
battery.
M52TU only:
Remove intake filter housing.
Pull Bowden cable upwards out of holder (1) and suspend from
throttle.
Loosen hose clamps (1).
Detach air intake hose section from throttle assembly and idle
actuator.
Installation:
To facilitate installation, fit air-mass flow sensor with intake
hose (1). Coat intake hose (1) with antiseize agent.
RA Replacing idle speed control valve (M52TU, M54)
BMW AG - TIS
11.02.2013 01:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
