3 Series E36 Z3 (M52TU) ROADST
Installation:
Pay attention to guide sleeves (1 ... 2), replace if necessary.
Ensure correct position of cover plate.
Installation:
Remove and clean release unit and release lever and grease
appropriate points,
refer to 21 51 500.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. Replace clutch disk if grease is sticky,
refer to 21 21 500.
Check clutch disk for friction rust in taper splines and replace
if necessary,
refer to 21 21 500.
Mechanically remove old grease and lining abrasion from the
taper splines of the clutch disc (with a cloth).
Clean and grease taper grooves and guide pin of
transmission input shaft.
The volume of grease required for this corresponds roughly to
the size of a grain of corn.
Grease,
refer to BMW Service Operating Fluids.
RA Removing and installing transmission (S5D 200G, S5D 250G)
BMW AG - TIS
11.02.2013 02:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
