3 Series E36 Z3 (M52TU) ROADST
Installation:
Adjusting display slide of trim:
-
Press adjuster (1) of display slide (2) against stop (3).
-
Position opening of trim (4) over opening of display slide (2).
-
Move preselector lever to "N" (NORMAL) position.
-
Insert trim on preselector lever and install.
-
Move preselector lever to "P" (PARK) position.
-
Display slide (2) is now adjusted.
Pull plug (6).
Lever out retainer (7).
Remove cable from counter support and detach towards front.
Unhook cable from eye.
Installation:
Insert turning lock with bore hole in nubs.
Mount cable in this position.
Remove retaining screws.
Tightening torque, 25 16 3AZ.
RA Removing and installing selector lever with mounting block
BMW AG - TIS
11.02.2013 03:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
