3 Series E36 Z3 (M52TU) ROADST
Release steering transmission from front-axle carrier.
Installation:
Replace self-locking nuts.
Tightening Torque,
refer to Technical Data 32 00 1AZ.
If necessary, remove the reinforcing cross struts
(Convertible/Roadster).
Unscrew left and right bolts and remove front-axle carrier.
Installation:
Up to model year 93:
1.
Remove paint from contact surfaces of front axle and engine
supports.
2.
Replace 4 screws.
3.
Coat screws on thread and head contact point with assembly
paste LM 48, Part No. 81 22 9 400 207.
Lubrication is not necessary when bolts 1 141 214 are
used.
4.
Install 4 new toothed ring discs between front axle and
engine carrier, even if there were no toothed ring discs fitted
previously.
Tightening Torque,
refer to Technical Data 31 10 1AZ.
Installation:
Since 1993 models:
Four ring-type lock washers are omitted due to tapered connection
at both rear mounting points.
Screws M12 X1.5 X 95 9.8
Tightening Torque,
refer to Technical Data 31 10 1AZ.
RA Replacing front axle support
BMW AG - TIS
11.02.2013 04:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -