3 Series E36 Z3 (M52TU) ROADST
33 11 011
Replacing shaft seal and input flange on final
drive (Type K / M / G)
Note:
Type K = lateral bearing cover with 4 screws
Type M = lateral bearing cover with 6 screws
Type G = lateral bearing cover with 8 screws
Remove final drive,
refer to 33 10 010.
Attach final drive to assembly stand with special tool 33 1 070.
Drain off fluid. Take off case cover.
Installation:
Replace seal.
Tightening torque,
refer to Technical Data 33 11 1AZ.
Pour in ATF,
refer to Technical Data.
Remove drive flange with a tire iron.
Caution!
Do not damage dust cover plate on drive flange.
Installation:
Replace circlip (1).
Twist circlip (1) until both ends settle into the groove.
Apply light coat of final drive oil to contact face of shaft seal on
driver flange. Insert drive flange and twist until spline on
flange engages in spline of differential bevel gear.
Insert drive flange further until retaining ring (1) locates
audibly.
RA Replacing shaft seal and input flange on final drive (Type K / M / G)
BMW AG - TIS
11.02.2013 05:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
