3 Series E36 Z3 (M52TU) ROADST
Remove differential.
Match side covers and shim of determined thickness, and do not
mix them up.
Installation:
Clean tapped bores thoroughly (tapper).
Heat plate spring to max. 100
°
C (thermo-chrome pin).
Mount crown wheel with two locally manufactured staybolts for
guiding.
Installation:
Install new bolts with Loctite No. 270. Tighten bolts in order of
1 ... 8.
Note Tightening Torque and torsion angle,
refer to Technical Data 33 12 1AZ.
Installation:
Install differential with ring gear and pulse gear.
Install side cover after marking with the appropriate washers (1)
and new O-ring (2). Tightening Torque,
refer to Technical Data 33 11 2AZ.
RA Replacing both bearings in final drive case (Type K) - final drive removed -
BMW AG - TIS
11.02.2013 05:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
