3 Series E36 Z3 (M52TU) ROADST
Punch mark both bearing caps.
Unfasten screws on both bearing covers and remove bearing
covers (turn if necessary, because the sealing ring grips firmly -
suction).
Caution!
Do not mix up bearing caps and spacers.
Secure spacers on bearing cap with a piece of wire, if necessary.
Installation:
Tightening Torque,
refer to Technical Data 33 11 2AZ.
With shims (1), the axial preload of the differential bearing (4000
N) and the torsional face runout of the crown and bevel gear is
set.
(2) = O-ring
Remove complete differential case.
Caution!
Do not bend the pulse generator wheel.
Remove lockplate.
RA Replacing bearing for drive pinion (Type K) - final drive removed -
BMW AG - TIS
11.02.2013 05:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -