3 Series E36 Z3 (M52TU) ROADST
If it is still not possible to take off brake drum, brake shoes will
have to be pushed back.
Locate one wheel stud bore in position approx. 50
°
before
vertical axis.
Insert special tool 34 4 010 in wheel-bolt bore as far as stop and
press down until tool bears on tooth profile.
Pull out special tool.
Cam on special tool unlocks slack-control lever and pinion of
automatic brake slack control is set back by tooth profile.
Repeat procedures until brake drum can be removed.
Installation:
Pinion must seat easily on threaded rod to guarantee
automatic slack control.
Disconnect handbrake cable. Remove rear brake shoes. Replace
brake shoes.
Installation:
Always replace all four shoes and use shoes of same make,
refer to Technical Data.
Replace return springs.
RA Removing and installing or replacing brake shoes of rear wheel brakes
BMW AG - TIS
11.02.2013 06:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -